Step Six: Adding piece #4 and #3
Grab piece #3 print side down and lay it on top of the zipper tape. Place piece #4 print side up under all your work and align with the flat edge. You will have a sandwich of piece #4 (print side up), the zipper and piece #3.
Sew as close to the zipper as you can. At this point, you should have four layers in total.
Turn piece #3 print side up and top stitch.
This is where you should be by now.
Step Seven: Adding the last zipper and piece #2 to the rest of the pouch
Place your second 14″ zipper right side up so it opens from right to left.
Place piece #2 print side down on the top edge of the zipper. Sew and put aside.
Take the belt/pouch piece and fold the seam allowance over the zipper tape.
Bring back piece #2 and attached zipper.
Pin the combined pieces to the zipper tape of piece #2 as shown below.
Sew using the zipper foot.
Step Eight: Adding piece #1
Place piece #1 print side down and pin the rest of the belt on top. Pin all around. Make sure you have the zippers open.
Stay-stitch 3/8″ all around.
Step Nine: Making the adjustable belt
For this step, we will be using the slider (on right) and the male part of the buckle.
Pass the decorative elastic band print side up, under and through the first hole of the slider. Over the bridge and down the other hole.
Repeat the same procedure with the buckle, under the first hole,
over the bridge, and out the other hole.
Hold the buckle with one hand and pull the end of the elastic about half way through and fold back the end to the slider. Working on the underside of the slider, thread the end of the elastic in through the first hole and out. Pull towards the buckle and fold the end of the elastic about 1 1/2″. Sew 1/8″ from the edge a few time to secure the elastic.