<\/noscript><\/figure><\/div>\n\n\nFeed the cord every other row. In total 50 rows. Stay between the same layer of printed and plain canvas. This will give the mat two distinctive sides. One with higher ridges from the cord and one with slightly lower.<\/p>\n\n\n\n
Leave about one inch sticking out the side on each run to secure the cord. You can also decide if you want to leave the cord loops showing for decoration purposes. If you don't, there's no need to keep the cord as one long piece which can be difficult to manage and feed all the way through the mat on each turn. You can just go a couple of turns and start with a new section of cord.<\/p>\n\n\n\n
I'm sure some readers will come up with easier ways to do this, so please share your ideas in the comments below.<\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\nAfter you have fed the cord in all 50 rows sew around the mat at 1\/4″ from the edge.\u00a0 This to join all the edges and secure very firmly the cords. <\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\nIf you don't want the cords as decoration (I didn't), cut off the ends that stick out of the mat.<\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\nStep Four: Making the fringe<\/h2>\n\n\n\n I am using my 6″ quilting ruler to create this fringe. \u00a0Take the strand of wool and tape it to the corner of the ruler.\u00a0 <\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\nWrap the wool around the ruler no bigger than 6 inches at a time. \u00a0It gets messy and difficult to handle if you wrap the wool any wider.<\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\nCut the strand of wool and place the sticky tape in the middle across the width of the wrapped wool to hold the strands in place. Do this to both sides of the ruler.<\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\nCut the top of the strands of wool with a small scissors.<\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\nCut the bottom. This is how it looks at this point.<\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\nPeel off the sticky tape at the bottom. \u00a0Gravity and the tape will keep the strands of wool in one line. \u00a0It doesn't have to be perfect since the fringed edge is meant to look shaggy but do the best you can.<\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\nTurn your ruler and do the same on the other side.<\/p>\n\n\n\n
Step Five: Stitching the fringe<\/h2>\n\n\n\n Take all the strands of wool and gently position them at the top edge of the mat.<\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\n Being careful to leave about 2.5″ hanging from the edge.<\/p>\n\n\n
\n
<\/noscript><\/figure><\/div>\n\n\n